linux mint 19 installer restarting











up vote
-1
down vote

favorite
1












as a project I have been building a supercomputer cluster out of old(ish) computers. I decided to use Linux mint and successfully installed it on two out of 5 computers however on the 3rd computer I encountered an error. the installer would run fine up until the select the drive screen at which point it reverts to the previous screen (select partioning)and this ends up in a loop (parting to drive select to portioning to drive select ect), I have tried both drives and nether make any change. it is not the boot media as it worked on the pervious 2 devices. I made a new boot usb a (this time 64 bit) and encountered the exact same issue. the computer specs are as follows:




  1. dual core intel chip

  2. 1.5 gz chip

  3. 2 GB ram

  4. 580 GB(one 500 GB and one 80 GB drives)

  5. previously running windows XP


I am unable to install the media on the 4th computer due to a issue with the boot loader.










share|improve this question




















  • 1




    Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
    – Keltari
    Nov 25 at 23:30






  • 1




    knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
    – Leo Cornelius
    Nov 25 at 23:59










  • no will give it a try in the morning, thanks!
    – Leo Cornelius
    Nov 26 at 0:45










  • care to explain the down vote?
    – Leo Cornelius
    Nov 26 at 11:15










  • @acejavelin thanks for the help mate, worked like a charm!
    – Leo Cornelius
    Dec 1 at 9:07















up vote
-1
down vote

favorite
1












as a project I have been building a supercomputer cluster out of old(ish) computers. I decided to use Linux mint and successfully installed it on two out of 5 computers however on the 3rd computer I encountered an error. the installer would run fine up until the select the drive screen at which point it reverts to the previous screen (select partioning)and this ends up in a loop (parting to drive select to portioning to drive select ect), I have tried both drives and nether make any change. it is not the boot media as it worked on the pervious 2 devices. I made a new boot usb a (this time 64 bit) and encountered the exact same issue. the computer specs are as follows:




  1. dual core intel chip

  2. 1.5 gz chip

  3. 2 GB ram

  4. 580 GB(one 500 GB and one 80 GB drives)

  5. previously running windows XP


I am unable to install the media on the 4th computer due to a issue with the boot loader.










share|improve this question




















  • 1




    Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
    – Keltari
    Nov 25 at 23:30






  • 1




    knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
    – Leo Cornelius
    Nov 25 at 23:59










  • no will give it a try in the morning, thanks!
    – Leo Cornelius
    Nov 26 at 0:45










  • care to explain the down vote?
    – Leo Cornelius
    Nov 26 at 11:15










  • @acejavelin thanks for the help mate, worked like a charm!
    – Leo Cornelius
    Dec 1 at 9:07













up vote
-1
down vote

favorite
1









up vote
-1
down vote

favorite
1






1





as a project I have been building a supercomputer cluster out of old(ish) computers. I decided to use Linux mint and successfully installed it on two out of 5 computers however on the 3rd computer I encountered an error. the installer would run fine up until the select the drive screen at which point it reverts to the previous screen (select partioning)and this ends up in a loop (parting to drive select to portioning to drive select ect), I have tried both drives and nether make any change. it is not the boot media as it worked on the pervious 2 devices. I made a new boot usb a (this time 64 bit) and encountered the exact same issue. the computer specs are as follows:




  1. dual core intel chip

  2. 1.5 gz chip

  3. 2 GB ram

  4. 580 GB(one 500 GB and one 80 GB drives)

  5. previously running windows XP


I am unable to install the media on the 4th computer due to a issue with the boot loader.










share|improve this question















as a project I have been building a supercomputer cluster out of old(ish) computers. I decided to use Linux mint and successfully installed it on two out of 5 computers however on the 3rd computer I encountered an error. the installer would run fine up until the select the drive screen at which point it reverts to the previous screen (select partioning)and this ends up in a loop (parting to drive select to portioning to drive select ect), I have tried both drives and nether make any change. it is not the boot media as it worked on the pervious 2 devices. I made a new boot usb a (this time 64 bit) and encountered the exact same issue. the computer specs are as follows:




  1. dual core intel chip

  2. 1.5 gz chip

  3. 2 GB ram

  4. 580 GB(one 500 GB and one 80 GB drives)

  5. previously running windows XP


I am unable to install the media on the 4th computer due to a issue with the boot loader.







linux-mint






share|improve this question















share|improve this question













share|improve this question




share|improve this question








edited Nov 26 at 5:39









Mureinik

2,27151525




2,27151525










asked Nov 25 at 22:24









Leo Cornelius

33




33








  • 1




    Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
    – Keltari
    Nov 25 at 23:30






  • 1




    knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
    – Leo Cornelius
    Nov 25 at 23:59










  • no will give it a try in the morning, thanks!
    – Leo Cornelius
    Nov 26 at 0:45










  • care to explain the down vote?
    – Leo Cornelius
    Nov 26 at 11:15










  • @acejavelin thanks for the help mate, worked like a charm!
    – Leo Cornelius
    Dec 1 at 9:07














  • 1




    Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
    – Keltari
    Nov 25 at 23:30






  • 1




    knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
    – Leo Cornelius
    Nov 25 at 23:59










  • no will give it a try in the morning, thanks!
    – Leo Cornelius
    Nov 26 at 0:45










  • care to explain the down vote?
    – Leo Cornelius
    Nov 26 at 11:15










  • @acejavelin thanks for the help mate, worked like a charm!
    – Leo Cornelius
    Dec 1 at 9:07








1




1




Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
– Keltari
Nov 25 at 23:30




Not much of a supercomputer cluster, when a single modern computer is faster. But, have if you are having fun, go at it :)
– Keltari
Nov 25 at 23:30




1




1




knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
– Leo Cornelius
Nov 25 at 23:59




knew someone would say that, quite frankly most computers do not have 9 cores and 12 GB of ram. the computers are not all identical.
– Leo Cornelius
Nov 25 at 23:59












no will give it a try in the morning, thanks!
– Leo Cornelius
Nov 26 at 0:45




no will give it a try in the morning, thanks!
– Leo Cornelius
Nov 26 at 0:45












care to explain the down vote?
– Leo Cornelius
Nov 26 at 11:15




care to explain the down vote?
– Leo Cornelius
Nov 26 at 11:15












@acejavelin thanks for the help mate, worked like a charm!
– Leo Cornelius
Dec 1 at 9:07




@acejavelin thanks for the help mate, worked like a charm!
– Leo Cornelius
Dec 1 at 9:07










1 Answer
1






active

oldest

votes

















up vote
0
down vote



accepted










Assuming the hardware is good, then something is likely wrong with partition table. Use Gparted and delete the current partition table and create a new one, then install Mint.






share|improve this answer





















  • thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
    – Leo Cornelius
    Dec 2 at 9:43











Your Answer








StackExchange.ready(function() {
var channelOptions = {
tags: "".split(" "),
id: "3"
};
initTagRenderer("".split(" "), "".split(" "), channelOptions);

StackExchange.using("externalEditor", function() {
// Have to fire editor after snippets, if snippets enabled
if (StackExchange.settings.snippets.snippetsEnabled) {
StackExchange.using("snippets", function() {
createEditor();
});
}
else {
createEditor();
}
});

function createEditor() {
StackExchange.prepareEditor({
heartbeatType: 'answer',
convertImagesToLinks: true,
noModals: true,
showLowRepImageUploadWarning: true,
reputationToPostImages: 10,
bindNavPrevention: true,
postfix: "",
imageUploader: {
brandingHtml: "Powered by u003ca class="icon-imgur-white" href="https://imgur.com/"u003eu003c/au003e",
contentPolicyHtml: "User contributions licensed under u003ca href="https://creativecommons.org/licenses/by-sa/3.0/"u003ecc by-sa 3.0 with attribution requiredu003c/au003e u003ca href="https://stackoverflow.com/legal/content-policy"u003e(content policy)u003c/au003e",
allowUrls: true
},
onDemand: true,
discardSelector: ".discard-answer"
,immediatelyShowMarkdownHelp:true
});


}
});














draft saved

draft discarded


















StackExchange.ready(
function () {
StackExchange.openid.initPostLogin('.new-post-login', 'https%3a%2f%2fsuperuser.com%2fquestions%2f1378311%2flinux-mint-19-installer-restarting%23new-answer', 'question_page');
}
);

Post as a guest















Required, but never shown

























1 Answer
1






active

oldest

votes








1 Answer
1






active

oldest

votes









active

oldest

votes






active

oldest

votes








up vote
0
down vote



accepted










Assuming the hardware is good, then something is likely wrong with partition table. Use Gparted and delete the current partition table and create a new one, then install Mint.






share|improve this answer





















  • thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
    – Leo Cornelius
    Dec 2 at 9:43















up vote
0
down vote



accepted










Assuming the hardware is good, then something is likely wrong with partition table. Use Gparted and delete the current partition table and create a new one, then install Mint.






share|improve this answer





















  • thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
    – Leo Cornelius
    Dec 2 at 9:43













up vote
0
down vote



accepted







up vote
0
down vote



accepted






Assuming the hardware is good, then something is likely wrong with partition table. Use Gparted and delete the current partition table and create a new one, then install Mint.






share|improve this answer












Assuming the hardware is good, then something is likely wrong with partition table. Use Gparted and delete the current partition table and create a new one, then install Mint.







share|improve this answer












share|improve this answer



share|improve this answer










answered Dec 1 at 13:36









acejavelin

5,03941528




5,03941528












  • thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
    – Leo Cornelius
    Dec 2 at 9:43


















  • thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
    – Leo Cornelius
    Dec 2 at 9:43
















thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
– Leo Cornelius
Dec 2 at 9:43




thanks! worked like a charm! Cluster up and running. Said cluster now running some pi calculations!
– Leo Cornelius
Dec 2 at 9:43


















draft saved

draft discarded




















































Thanks for contributing an answer to Super User!


  • Please be sure to answer the question. Provide details and share your research!

But avoid



  • Asking for help, clarification, or responding to other answers.

  • Making statements based on opinion; back them up with references or personal experience.


To learn more, see our tips on writing great answers.





Some of your past answers have not been well-received, and you're in danger of being blocked from answering.


Please pay close attention to the following guidance:


  • Please be sure to answer the question. Provide details and share your research!

But avoid



  • Asking for help, clarification, or responding to other answers.

  • Making statements based on opinion; back them up with references or personal experience.


To learn more, see our tips on writing great answers.




draft saved


draft discarded














StackExchange.ready(
function () {
StackExchange.openid.initPostLogin('.new-post-login', 'https%3a%2f%2fsuperuser.com%2fquestions%2f1378311%2flinux-mint-19-installer-restarting%23new-answer', 'question_page');
}
);

Post as a guest















Required, but never shown





















































Required, but never shown














Required, but never shown












Required, but never shown







Required, but never shown

































Required, but never shown














Required, but never shown












Required, but never shown







Required, but never shown







Popular posts from this blog

Terni

A new problem with tex4ht and tikz

Sun Ra